Publicidad
Idiomas disponibles
Idiomas disponibles
5.2 ASSEMBLY OF THE SNOW DISCHARGE GUIDE
1. Put the snow discharge guide on the base and make sure the assembly hole in the
bottom of the snow discharge guide aligns with the holes in the base. (Fig.3A)
2. Fix the snow discharge guide onto the motor housing with the three M6 bolts provided.
(Fig.3A)
3. Tighten the bolts with a Hex wrench. (Fig.3B)
Snow discharge guide
6
Bolt
Fig.3A
OPERATION
Always exercise caution when using your snow blower, employing strict safety
measures no matter your level of experience or expertise.
Always wear safety goggles or safety glasses with side shields during power tool
operation. Failure to do so could result in objects being thrown into your eyes and
other possible serious injuries.
Only use the attachments recommended by the manufacturer. The use of attach-
ments or accessories not recommended can result in serious personal injury.
Inspect the entire product for damaged, missing, or loose parts before each use.
Tighten all fasteners and do not operate this product until all missing or damaged
parts are replaced.
Page 14-English
Fig.3B
GREEN MACHINE 62V CORDLESS SNOW BLOWER
6.1 INSTALL AND REMOVE THE BATTERY PACKS
FULLY CHARGE THE BATTERY PACK BEFORE FIRST USE.
Always remove the battery pack from the product when you are assembling parts,
adjusting, cleaning, or when the blower is not in use. Removing the battery pack will
prevent accidental starting that could cause serious personal injury.
TO INSTALL THE BATTERY PACK:
Power your equipment with the Green Machine
GMBA6200-40, GMBA6200-80, and GMBA6200-120. The use of any other battery
packs may create a risk of injury and fire. *The use of model GMBA6200-25 is not
recommended with this product.
NOTE: Check to ensure that the power switch is set to off before battery assembly.
1. Raise the battery cover. (1, Fig.4)
2. The snow blower is equipped with two battery compartments, which accommodate
two battery packs at the same time.
3. Align the ribs of the battery pack with the mounting slots in the battery port. Insert
the battery pack into the battery holder until you hear a "click". Ensure that the
latch snaps into place and the battery feels secure. (2, Fig.4）
4. Insert the other battery pack into the other battery compartment in the same way.
5. Close the battery cover.
1
Fig. 4
GREEN MACHINE 62V CORDLESS SNOW BLOWER
®
battery pack only, models
2
Page 15-English
Publicidad
