UPPAbaby RumbleSeat Instrucciones De Montaje página 12

EN
Australia, New Zealand
Extreme care should be taken if the stroller is used on stairs or an escalator.
NEVER leave safety harness connected when not fitted to a child in the stroller as this
may create loops that could cause a strangulation hazard.
DO NOT make any alterations or modifications to the RumbleSeat with products
not supplied by the manufacturer as this may cause instability or structural damage
not covered under warranty.
The stability of the product will be impaired in high winds with the rain shield fitted
and should be steadied by an adult at all times.
Before each use, inspect your RumbleSeat to make sure the brackets are fully engaged
by pushing down on the top of the RumbleSeat firmly. It should not move.
Children should not be left unattended in the product with rain shield fitted.
Stroller can fold with adapters attached, however, the RumbleSeat must be removed
and the main seat must be facing forward and in an upright position.
Rain shield must be removed when indoors and in hot weather to prevent
overheating and possible risk of suffocation.
Excessive weight may cause a hazardous unstable condition to exist. The product will
become unstable if the manufacturer's recommended load is exceeded.
Any load attached to the handle affects the stability of the stroller.
To avoid instability of the stroller, only attach one weight bearing accessory to the
stroller handle bar at a time.
Audible "click" must be heard to confirm that each attachment is connected properly.
Make sure latch on left side of stroller is properly engaged before lifting or carrying
the vehicle.
Use only replacement parts supplied or approved by UPPAbaby.
Complies with AS 2088 and TPA 1974 NO. 8 Consumer Product Safety Standard for
Prams and Strollers.
20