Troubleshooting Chart - BERG Bar Line DIRECT DRAW Manual De Instrucciones

TROUBLESHOOTING CHART

5.1 Troubleshooting guide chart
5.1 Troubleshooting chart
Follow the next steps before requesting warranty service. Failure to do so, may result in
service charges for you and may void your warranty:
1)
Refrigerator doesn't work:
a.
Check that the machine is still connected.
b.
Check that the ON/OFF button is in the ON position.
c. Check the knob position of thermostat are different from "0" value.
2) Refrigerator doesn't reach temperature :
a.
Check that the thermostat is not in OFF position.
b.
Check that the machine is not in the defrost cycle.
c.
Ensure Equipment is in a ventilated place and removed minimum of 2
inches from any other appliance and away from any heat source.
d.
The environment maximum temperature must be 38 °C/ 100°F.
e.
To insure proper air flow, product must not be placed higher than the
maximum level mark located on the internal wall of the unit.
f.
Check if the condenser is clean.
g.
Check that the gasket is in good condition and door is sealed.
h.
Check that the fan is moving.
i.
Don't put any food inside until the unit has reached the proper temperature.
3)
There is water inside the refrigerator:
a.
Check that the drain pan inside the cabinet is in position.
b.
Check that there is not food clogging the drain line.
4)
There is water under the refrigerator:
a.
Check that the drain pipe is over the pan.
b.
Check that the cabinet is level.
Warning: To i n s u r e proper operation of equipment, it is recommended that the unit is
on for 24 hours prior to the introduction of food.
9