Publicidad
Idiomas disponibles
Idiomas disponibles
• Do not connect the appliance to the mains without checking
that the voltage on the rating plate and that of your household
are the same.
• VERY IMPORTANT: Do not immerse the fan in water or any
other liquid.
• This appliance has been designed for domestic only. Don't
allow children play with the appliance. Keep the fan out of the
reach of children.
• Make sure the appliance is not in direct contact with hot
surfaces or objects.
• Always place it on a flat and stable surface.
• Do not use outdoors or in any room with high humidity or
exposure to water.
• If the power cord or any other component is damaged, it must
be replaced by the manufacturer or by its after-sales service or
similar qualified personnel in order to avoid a danger.
ASSEMBLING INSTRUCTIONS
• Make sure the place where the fan is going to be installed is wide enough, to improve the flow of air through
the room
• To prevent the blades from colliding with any object, it is recommended to leave a minimum distance of
0.60 meters (x) on each side.
• The fan must be installed in such a way that the blades are 2.3 meters from the ground (y).
• The location chosen for its placement must be able to support a minimum of 45 kg in order to support the
weight of the fan.
• Note: the fixing screws (11) (included) are designed to be used with the fan on a concrete or wooden ceiling.
If the installation is carried out on a different material (false ceiling, etc.) it is recommended to use the
appropriate fixing screws for that material (not included). (Fig 1) (Fig 2)
• Place the ceiling support frame (2) in the desired location, ensuring that the ceiling power cables are
centered to make the subsequent connection. A waterproof rubber cover (16) is included to be placed
between the roof and the roof support frame (2) if you consider it necessary.
• To mount the blades (1),
Screw each blade anchor (14) to the blade with the set screws (15) and nut.
• Place the blades (1) in the engine (7) screwing them firmly so that they do not oscillate when they are in
operation. (Fig 3)
• Then, place the LED light support (8). First, loosen the screws of the round anchor, located at the bottom of
the motor, pass the light cable through the hole and screw it. (Fig 4)
• Next, connect the LED lights (9) (Blue-Blue / White-White). (Fig 5)
• The LED lights are attached to the support by magnets so they can be moved for placement.
• Unscrew the upper screws of the engine mount anchor (5), slide the plastic plunger down and remove the
pin. (Fig 6)
• Remove the retaining clip to extract the pin from the lower end of the engine support anchor (5)
• Insert the roof trim (4) and the engine trim (6).
• Then, pass the upper motor cables inside the motor support anchor (6) to the other edge. (Fig 7)
12
Publicidad
