Publicidad
Idiomas disponibles
Idiomas disponibles
- Any obstacle between this unit and a Bluetooth device
can reduce the operational range.
- Keep this player away from any other electronic device
that may cause interference.
1. Turn on the Bluetooth function on your device.
2. Switch player's source to Bluetooth, Display panel
shows "BLUEPORT", then show
"NO BT" (if there's no Bluetooth device connected).
3. Press and hold "12/PAIR " button on remote control
for seconds to activate Bluetooth pairing mode, display
panel shows "PAIRING".
4. Search for Bluetooth device with your device.
5. Select "BLUEPORT" in the pairing list.
6. Enter default password "0000", if the pairing
succeeds, display panel shows "BLUEPORT" again.
7. To disconnect connection, turn off the Bluetooth
function on your
Tip
- If there's a connection exist, hold and press "12/ PAIR"
button on remote control for seconds will re-activate the
pairing mode, the connection will be interrupted.
- If there's no other Bluetooth device pair with this
player in two minutes, the player will recovery previous
connection.
- The player will also be disconnected when your device
is moved beyond the operational range.
- If you want to reconnect your device to this player,
place it within the operational range.
- If the device is moved beyond the operational range,
when it is brought back, please check if the device is still
connected with the player.
- If they are connected, display panel shows "BLUEPORT".
- If the connection is lost, display panel shows "NO BT",
follow the instruction above to pair your device to the
player again.
Listen to music from Bluetooth device
• If the connected Bluetooth device supports Advanced
Audio Distribution Profile (A2DP), you can listen to the
music stored on the device through the player.
If the device also supports Audio Video Remote Control
Profile (AVRCP) profile, you can use the player's remote
control to play music stored on the device.
1. Pair your device with the player.
2. Start play music via your device (if it support A2DP)
3. Use supplied remote control to control play (if it
support AVRCP).
- To pause/resume play, press the 12/ PAIR button.
- To skip to a track, press the
40
, 7 / 8, 1 buttons.
Adjust Volume Level
During play, press the VOL+/- buttons to increase/
decrease the volume level.
Mute Sound
During play, press the MUTE button to mute or restore
sound. Press this button again or VOL-/+ buttons to
cancel the effect.
Adjust the brightness level of display
In the standby mode, press the
remote control to adjust the brightness level of display.
Picture View Options
Preview Pictures
1. During play, press the 3 button.
- The thumbnails of 12 pictures are displayed.
2. Select one of the following:
- a picture
- the slide show option
- the menu option
- the next/previous page (if available)
3. Press the ENTER button to:
- play the selected picture
- start slide show of all pictures
- enter the menu where each remote key function is
explained
- turn to the next/previous page (if available)
Select a Slide Show Play Mode
• During play, press the PROG buttons repeatedly to
select a slide-show play mode.
Rotate Picture
• During play, press the
picture.
Zoom in/out Image
During video play, press the ZOOM button repeatedly to
zoom in/out the image.
- When the image is zoomed in, you can press the
,
to pan through the image.
Adjust Settings
Introduction
This chapter describes how to use the SETUP menu.
Most settings and adjustments are required to be set
when you first use the system.
1. Press the SETUP button.
2. Press the
, 1 buttons to select a setup page .
/ 1 button on the
, 1,
,
buttons to ro tate the
DVD Microsystem
, 1,
Publicidad
