Publicidad
Idiomas disponibles
Idiomas disponibles
Radio Operation
Scanning for Radio Stations
The unit will automatically select a FM radio station with
a good signal.
1. Select the TUNER mode by pressing the FUNCTION
button repeatedly on the unit or pressing the TUNER/
BLUETOOTH button on the remote control until the
display reads "TUNER".
2. To activate automatic scanning, press and hold the
PROG button on the remote control.
The LED dis play will read "AUTO" before scanning.
3. All stations found will be automatically stored.
4. To select and listen to a saved radio station, press the
7 / 8 buttons on the remote control.
Searching for a Station Automatically
In TUNER mode, press and hold the
the remote control until the tuner starts searching for a
station. The tuner will stop searching after tuning into a
radio station.
• The search may not stop at a station with a
very weak signal.
Searching for a Station Manually
In TUNER mode, repeatedly press the
the remote control until the desired frequency reception
quality is found.
• With FM radio it may be necessary to fine tune
each station by pressing the
the remote control repeatedly. Each press will
adjust the frequency by 0.05MHz. If reception
is still poor adjust the position of the aerial or try
moving the radio to another location.
For Better Reception
Fully unwind the FM aerial. Extend the FM aerial
and place it in the position that offers the best sound
reception.
/ 1 buttons on
/ 1 buttons on
/ 1 buttons on
• The unit will automatically switch between
stereo and mono mode. This is helpful when
receiving poor signal reception.
Presetting Stations
You can preset up to 20 FM stations.
Programming Radio Stations Automatically
Press and hold the PROG button for 2 seconds to
activate automatic programming. All available stations
are programmed in according to waveband signal
reception strength (from strongest to weakest).
• The first programmed radio station is broadcast
automatically.
• Press the 0-9 buttons in pairs (e.g., 01, 02, 03, etc.) to
select the desired preset station.
Programming Radio Stations Manually
1. Tune into the desired radio station, then press the
PROG button.
2. Press the 0-9 buttons in pairs (e.g., 01, 02, 03, etc.)
or 7 / 8 buttons to select the desired preset number
location for the selected radio station's frequency.
3. Press the PROG button to set and store the station.
4. Repeat steps 1 to 3 above for each radio station you
want to store in the unit's memory with a preset number
location.
Recalling a Preset Station
Once you have saved a station to one of the preset
buttons, you can recall it by pressing the 0-9 or 7 / 8
buttons on the remote control.
• The stored stations will be saved into the
memory and power off will not erase it. Storing
a new station in a preset location will erase the
previously stored station in that location.
• While the unit is in TUNER mode, press 3
button to erase the selected preset memory.
43
Publicidad
