Publicidad
Idiomas disponibles
Idiomas disponibles
D- SETTING / USING
D- SETTING / USING
D1
Remote controls
To program a remote control : Press «RF-Learn» button for 2 seconds, and the LED display shows «CS». Then
push any button of the transmitter; the LED flashes twice and then be off. And the remote memory has completed
(picture 1,2 et 3)
LED2
Affichage
LED1
LED
viewer
1
2 Sec
You can now use your remote control as follow :
LED
ON
full opening
OFF
release relay exit EXT+
EXT-
To cancel the remote controls memory :
Press and maintain the «RF-Learn» button until the LED display indicates
D2
System learning process, reset process and LED display
The remote control memory storing operation must be over before starting the final system learning
process.
(1) To complete the system learning process, disengage your gate and remove it in the middle. Then re-engage
it again.
Step 1 : Simultaneously hold «SET» + «DOWN» for 3 seconds, the LED display shows « LE » (Pictures 1,2 and 3,
see following page)
Step 2 : Press the button on the top left of your remote control during 1 to 3 seconds, the LED display shows then
« LP » (Pictures 4 and 5)
Step 3 : The gate goes to auto-learning. It means it closes a first time then opens and closes again. Please wait
for the learning process to be completed.
LED
2
Affichage LED
LED viewer
clignote 2 fois
flashes twice
pedestrian
opening
(By default it is locked, so the buttons of your
remote control are inactive). To use the remote
control, unlock the lock button (the LED light up
LED screen turns
LED écran éteint
off
3
Lock button
each time you press a button).
(approx. 10 s.).
EN
31
Publicidad
