Urmet SCS Sentinel PRO P501BU-PCB1 Manual página 32

If your gate is opening when you start the programmation, stop the program to push on SET. L» appears on the
display, wait for it to turn off then go on the program 1 to reverse the rotation direction of your gate (see following
page).
LED1
LED2
LED3
1
3
ON
LED1
LED2
OFF
LED3
4
(2)To reset factory settings.
LED1
Press UP and DOWN for 3 seconds, and the LED display shows « CL ».
LED2
LED3
1
1
LED Display
32 EN
Push 3
Appuyer
3 Sec
1
Appuyer
ON
2
Push 1-3
Appuyer
OFF
1~3 Sec
sec
ON
4
Appuyer
OFF
1~3 Sec
5
Appuyer
3 secondes
2
Push 3
Appuyer
3 secondes
sec
2
« -L » : the system learning is not done or not realized.
« OP » : the system is in normal operation
To program, press SET button for 3 seconds. When the LED display changes from «
OP » to « 1 », press UP or DOWN to change the function settings (1 to P). Then press
SET to enter the sub function within each group, press UP or DOWN to select sub
functions and press SET to valid
« LE » : Enter the learning mode and then wait for learning instructions.
« LP » : the system learning is in process.
« CL » : Reset factory setting.
sec
2
Appuyer
3 Sec
3
6
Programmable functions
5