EINHELL Expert TE-DY 18 Li Manual De Instrucciones Original página 18

6.6 Setting the screwing depth (Figure 6)
The depth setting ring (2) off ers latching settings
for pre-selecting the depth to which the screw is
screwed into the workpiece.
PLUS direction: Increased screwing depth
MINUS direction: Shorter screwing depth
The best way to establish the required depth set-
ting is to perform a screwing test.
Press the tip of the screw fi rmly against the ma-
terial in question until the screwing depth stop (1)
comes up against the workpiece and the coupling
disengages.
6.7 Changing the tool insert
To change the tool insert, rotate the screwing
depth stop (1) with the depth setting ring (2) to
the maximum screwing depth and pull off the tool
insert to the front (use pliers if necessary).
6.8 Screws
It is best to use self-centering screws (e.g. cross
recessed head), as these will enable you to work
safely and reliably. Always make sure that the tool
insert used is of the same size and shape as the
screw.
6.9 Removable holding clip (Fig. 1 / item 6)
When the holding clip (6) is mounted, the device
can be attached e.g. to a belt. The removable hol-
ding clip can be screwed either to the left or right-
hand side of the equipment. It is optional – it does
not need to be attached if you do not need it.
7. Cleaning, maintenance and
ordering of spare parts
Danger!
Always pull out the battery pack before starting
any cleaning work.
7.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
•
We recommend that you clean the device
immediately each time you have finished
using it.
•
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use
Anl_TE_DY_18_Li_SPK13.indb 18 Anl_TE_DY_18_Li_SPK13.indb 18
GB
cleaning agents or solvents; these could at-
tack the plastic parts of the equipment. Ensu-
re that no water can seep into the device. The
ingress of water into an electric tool increases
the risk of an electric shock.
7.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.
7.3 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
For our latest prices and information please go to
www.Einhell-Service.com
8. Disposal and recycling
The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.
9. Storage
Store the equipment and accessories in a dark
and dry place at above freezing temperature. The
ideal storage temperature is between 5 and 30
°C. Store the electric tool in its original packaging.
- 18 -
24.10.2023 14:13:39 24.10.2023 14:13:39