Twin-Star International 73719/23MM6072VMA Manual De Instrucciones página 10

9. Locate Right Front Door (O) and Left Front Door
(N). Slide door hinge keyhole into panel hinge
bracket. (Diagram 1)
Use Phillips Head Screwdriver to tighten screws.
(Diagram 2)
TO ADJUST HINGES
To adjust door forward or backward change keyhole
slot position. (As Shown In Diagram 3a)
To adjust door right or left loosen/tighten screw.
(As Shown In Diagram 3b)
To adjust door up or down adjust bracket height.
(As Shown In Diagram 3c)
Attach the Knob (FF) to the Left Front Door
(N) and Right Front Door (O), use the bolts
attached through the pre-drilled holes in the
doors. Then use a Phillips Head Screwdriver
to tighten the bolts.
Hardware Used
FF Knob
10. Choose desired height of Shelf (P) and place the
four Shelf Pin (DD) into same height shelf holes
inside side panels. Insert Wood Shelf (P), allow
Wood Shelf (P) to rest on the Shelf Pin (DD).
Hardware Used
DD Shelf Pin
Fig. 9
x 2
Fig. 10
x 8
9
O
N
FF
P
DD