Twin-Star International 73719/23MM6072VMA Manual De Instrucciones página 8

3. Locate Hearth/Base (A) and set out finished side up
on the floor.
Insert one Wood Dowel (CC) into each of the
pre-drilled holes.
Using two (2) persons lift and attach the completed
front assembly from step 2 to the Hearth/Base (A).
Make sure that Wood Dowels (CC) are seated into
the pre-drilled holes in the hearth/base. Using
Bolt (AA) and Washer (BB) attach panels through
pre-drilled holes in the mounting blocks.
HAND TIGHTEN ONLY.
Hardware Used
Bolt
AA
1/4 in. x 1-1/4 in.
Washer
BB
1/4 in. x 3/4 in.
CC Wood Dowel
4. Insert one Wood Dowel (CC) into each of the
pre-drilled holes on the top edges of the Assembly
from step 3. Then locate Center Shelf (G) and lay
fi nished side up on top of completed assembly.
From the inside, attach Center Shelf (G) using Bolt
(AA) and Washer (BB) through the pre-drilled holes
in the mounting blocks.
HAND TIGHTEN ONLY.
Hardware Used
Bolt
AA
1/4 in. x 1-1/4 in.
Washer
BB
1/4 in. x 3/4 in.
CC Wood Dowel
5. Insert one Wood Dowel (CC) into each of the
pre-drilled holes.
Push the Left Upper Side Panel (I) and Right Upper
Side Panel (J) snug to the Center Upper Front Panel
(H). Make sure the Wood Dowels are seated in the
pre-drilled holes.
Connect the Left Upper Side Panel (I), Right Upper
Side Panel (J) and Center Upper Front Panel (H)
with Connection Plate (GG), tighten Screws (EE)
through the pre-drilled holes.
Hardware Used
CC Wood Dowel
EE
Screw
Connection Plate
GG
(pre-attached)
Fig. 3
CC
x 8
x 8
x 8
Fig. 4
CC
x 10
x 10
x 9
Fig. 5
x 4
CC
x 2
x 2
7
AA
BB
A
G
BB
AA
EE
GG
H
J
CC
CC
I