Forch 5331 2 2 Manual Original página 25

max. [mm]
D b
75 30
Rotating the machine head
Pull the plug out of the socket before carry-
u
ing out any work on the power tool.
cutting with a guide block (20) or for left-handed
persons.
Completely unscrew the four screws. Rotate the
machine head carefully, without removing it
from the housing, into the new position. Screw in
and retighten the four screws.
Dust/Chip Extraction
The dust from materials such as lead paint, some
types of wood, minerals and metal can be harmful
to human health. Touching or breathing in this dust
can trigger allergic reactions and/or cause respirat-
ory illnesses in the user or in people in the near vi-
cinity.
Certain dusts, such as oak or beech dust, are clas-
sified as carcinogenic, especially in conjunction
with wood treatment additives (chromate, wood
preservative). Materials containing asbestos may
only be machined by specialists.
– Use a dust extraction system that is suitable for
the material wherever possible.
– Provide good ventilation at the workplace.
– It is advisable to wear a P2 filter class breathing
mask.
The regulations on the material being machined
that apply in the country of use must be observed.
Avoid dust accumulation at the workplace.
u
Dust can easily ignite.
1 609 92A 7F0 • 17.11.22
[mm]
d [min –1 ] [m/s]
M 14 11,000 45
English
The machine head can
be rotated in 90° incre-
ments. This enables
the on/off switch to be
brought into a more
convenient position for
particular working situ-
ations, such as cutting
operations using the
extraction guard for
English
Operation
English
Start-Up
English
Pay attention to the mains voltage! The
u
voltage of the power source must match the
voltage specified on the rating plate of the
power tool.Power tools marked with 230 V
can also be operated with 220 V.
Products that are only sold in AUS and NZ:
u
Use a residual current device (RCD) with a
nominal residual current of 30 mA or less.
When operating the power tool using a mobile
generator that does not have sufficient reserve ca-
pacity or an adequate voltage control system with
inrush current boost converter, loss of perform-
ance or atypical behaviour may occur upon switch-
on.
Please check the suitability of the power generator
you are using, particularly with regard to the mains
voltage and frequency.
Soft start
English
The electronic soft start limits the torque when the
power tool is switched on and increases the ser-
vice life of the motor.
Switching on/off
English
To start the power tool, push the on/off switch (3)
forward.
To lock the on/off switch (3) in position, push the
on/off switch (3) forward and down until it clicks
into place.
To switch off the power tool, release the on/off
switch (3); or, if the switch is locked, briefly push
the on/off switch (3) backward and down and then
release it.
Always check abrasive tools before using
u
them. The abrasive tool must be fitted prop-
erly and be able to move freely. Carry out a
test run for at least one minute with no load.
Do not use abrasive tools that are damaged,
run untrue or vibrate during use. Damaged
abrasive tools can burst apart and cause injur-
ies.
Restart protection
English
The restart protection feature prevents the power
tool from uncontrolled starting after the power sup-
ply to it has been interrupted.
To restart the tool, set the on/off switch (3) to the
"off" position and then switch the power tool on
again.
In rare cases, certain interference pulses can
cause the restart protection to activate. In such
English | 25