Publicidad
Idiomas disponibles
Idiomas disponibles
Operating Instructions
Fig. 9
Inserting & Releasing Battery Pack
(Fig. 9, 10)
To insert battery pack: Set Forward/ Reversing
lever to the center (off position). Slide charged
(6)
Battery Pack 6 into the housing until the battery
pack locks into position (Fig. 9).
To check if the battery is locked in place, lightly
pull the battery in the opposite direction. If the
battery moves, do not use the tool and repeat
the insertion procedure until the battery is
locked in place and does not slide backwards.
Your tool is equipped with a secondary locking
latch to prevent the battery pack from complete-
ly falling out of the handle, should it become
loose due to vibration.
To remove battery pack: press the Battery Pack
Release Button 7 and slide the battery pack to-
wards the front of the tool. Press the battery
Fig. 10
pack release button again and slide the battery
pack completely out of tool housing (Fig. 10).
Temperature Overload Protection
Avoid using battery operated tools continuously,
for long periods of time, while subjecting the
tool to overload conditions, such as drilling with
large diameter accessories into hard materials.
Using battery powered tools at extreme loads,
(7)
may cause the battery to exceed its allowable
operating temperature range. When the battery
exceeds normal operating temperature caused
by overload, the speed of the tool may be re-
duced and the tool may appear to lose power.
To regain the tool's full performance, the battery
must be allowed to cool, until the operating tem-
perature returns to normal.
15
2610070413 GSR18V800C 202308.indd 15
8/3/23 11:05 AM
Publicidad
