Publicidad
Idiomas disponibles
Idiomas disponibles
User Interface
(Fig. 11)
STATUS INDICATOR LED
The LED bar at the top of the user interface il-
luminates in various colors to help the user iden-
tify the status of the tool.
• When the status indicator LED 8a is green the
tool and battery pack are operating normally
and temperatures are ok.
• If the indicator changes to yellow it means
that the tool or battery temperatures have
risen to a critical level. It is recommended to
allow the tool to cool down.
• If the indicator turns red the tool will shut off
to protect itself and/or the battery pack from
an overheating situation.
• The status indicator LED 8a will also blink
blue when the precision clutch override 8e
or KickBack Control 8c buttons are held for
7 seconds. This will reset the tool settings to
factory default.
KICKBACK CONTROL (RAPID SHUT-OFF)
To ensure better control of the tool dur-
ing operation, this tool is design to shut-
off while in use if a sudden or unexpect-
ed bind up situation occurs. Bind up occurs
when the bit gets jammed during operation,
which forces the bit to stop spinning abruptly. If
this occurs, the tool will shut down and the Kick-
Back Control will be indicated by flashing LED
lights on the tool.
KickBack Control can be turned off by the user.
Button 8c on the user interface 8 will toggle the
feature on and off. Status is indicated with "On"
and "Off" LEDS 8b on the User Interface 8. If the
power tool is not used for longer than 5 minutes,
or if the battery is removed, KickBack Control
automatically turns back on.
Please note that the indicator light may not be
visible from all directions or in bright sunlight.
When the switch trigger is pressed, operator is
notified about the KickBack Control.
16
2610070413 GSR18V800C 202308.indd 16
Operating Instructions
Fig. 11
(a)
(f)
(e)
PRECISION CLUTCH OVERRIDE
This tool features an adjustable clutch with out-
put torque increasing as the clutch ring is rotat-
ed through the settings from 1 to 20. By default,
at a given torque setting, the tool senses when
the clutch begins to slip, and automatically
shuts off the motor thereby reducing wear and
tear on the clutch as well as the resulting noise.
This is what we call precision clutch.
This automatic motor shut-off can be overridden
by pressing the "P-Clutch" button 8e on the foot
of the tool so that the "off" indicator 8f lights
up. In this mode, the motor will continue to run
whenever the trigger is pressed regardless of
any clutch slippage allowing for small turns of
the screw.
BUILT IN LED WORK LIGHT
Your tool is also equipped with an LED light 8d
that turns on automatically when the switch is
activated, for better visibility when drilling/ driv-
ing. The light turns off automatically a short time
after the trigger is released. You can adjust this
time frame using Bosch Tool Box app. See "Con-
nectivity" section.
(8)
(b)
(c)
(d)
8/3/23 11:05 AM
Publicidad
