Descargar Imprimir esta página

Greencut ASE12000 Manual De Instrucciones página 67

Astilladora

Publicidad

Idiomas disponibles

Idiomas disponibles

Load a log onto the beam against the endplate (Max log length is 63.5cm - 25").
BAD
LOG
ATTENTION
If a log gets stuck, embedded or will not split completely, push the control lever in the reverse
direction and allow the splitter to strip the log from the wedge.
If the log remains stuck, embedded or will not split, turn the machine off and use a hammer
and crow bar to remove the log.
ALWAYS keep hands clear of the log and wedge while it is retracting.
Always keep the work area clean and free of split wood and debris.
Push control lever FORWARD by one hand to split the log.
Push control lever BACKWARD by one hand to return wedge to its original position.
MAINTENANCE
Improper maintenance and storage of the log splitter may void the warranty.
ATTENTION
Removal of safety devices, improper maintenance, replacement of items with non-original
spare parts may cause bodily injury.
Before performing maintenance, the log splitter must be placed in maintenance mode. Turn off
the engine and move the control lever forward and backwards to relieve the hydraulic pressure.
After performing any maintenance work, make sure all guards, shields and safety features are
put back in place before operating the log splitter.
Regularly grease axle and wheel bearing area or when needed.
After the wheel bearings have been greased make sure the axle nuts and pins are in place
and secure.
Periodically check that all clamps, screws and hoses are tight and not leaking.
Clean and lightly lubricate all moving parts or when needed.
Use a glossy enamel spray paint to touch up scratched or worn painted metal surfaces.
Never exceed load capacity rating of 22 tons, as it would damage the log splitter.
GOOD
LOG
67
BETTER
LOG
EN

Publicidad

loading