Publicidad
Status
Four (4) LEDs show green
No LED showing
One (1) LED quick-flashes yellow, then one or more
LEDs show green
One (1) LED quick-flashes red
3.5
Indicators showing the state of health of the Li-ion battery
Hilti recommends checking the state of health of the Li-ion battery every time before charging.
To check the battery's state of health, press the release button of the battery and hold it down for longer
than three seconds. The system does not detect a potential malfunction of the battery due to misuse, for
example battery dropped or pierced, external heat damage, etc.
Status
All LEDs show in sequence, followed by one (1)
LED showing constantly green.
All LEDs show in sequence, followed by one (1)
LED quick-flashing yellow.
All LEDs show in sequence, followed by one (1)
LED showing constantly red.
3.6
Items supplied
Charger, operating instructions.
Other system products approved for use with this product can be found at your local Hilti Store or at:
www.hilti.group
4
Technical data
Weight
Rated output voltage
Maximum output power
Storage temperature
Ambient temperature for operation
5
Operation
WARNING
A damaged supply cord presents a hazard! If the supply cord or extension cord is damaged while work is
in progress, immediately disconnect the product and the cord from the electricity supply. Do not touch the
damaged part of the cord!
▶ Regularly check all supply cords.
▶ Replace defective extension cords.
▶ Otherwise, contact Hilti Service.
18
English
Meaning
The battery is being charged, state of charge:
≥ 80 %
The battery is fully charged, charging has ended.
Charging interrupted. The battery might be outside
the permissible temperature range.
Charging resumes automatically as soon as the
applicable parameters return to specification. If
necessary, bring the battery to the recommended
charging temperature.
The Li-ion battery is locked and cannot be used.
Consult Hilti Service.
Meaning
The battery can remain in use.
The check to ascertain the battery's state of health
did not complete. Repeat the procedure, or consult
Hilti Service.
If a connected product can still be used, the re-
maining battery capacity is below 50 %.
If a connected product can no longer be used, the
battery has reached the end of its useful life and
has to be replaced. Consult Hilti Service.
C 6-22
0.84 kg
10.8 V ... 21.6 V
240 W
−20 ℃ ... 70 ℃
−17 ℃ ... 60 ℃
2275224
C 8-22
1.45 kg
10.8 V ... 21.6 V
450 W
−20 ℃ ... 70 ℃
−17 ℃ ... 60 ℃
*2275224*
Publicidad
