Publicidad
Use of a ground fault circuit interrupter (residual current device, RCD) with a maximum tripping current of
30 mA is recommended.
5.1
Switching on charger and charging battery
WARNING
Explosion hazard if any attempt is made to charge unapproved batteries. Injuries and damage to the
charger can result.
▶ Do not attempt to charge non-rechargeable batteries.
▶ Use only Hilti-approved batteries with this charger.
CAUTION
Short-circuit due to moisture or dampness Damage to the product is the result.
▶ Use the product only indoors.
▶ Keep the product away from moisture and dampness.
1. Plug the supply cord into the power outlet.
▶ The LED shows green.
2. Engage the battery on the battery interface.
▶ The battery is charging.
3. When the battery is fully charged, remove it from the charger.
6
Care and maintenance
WARNING
Electric shock hazard! Attempting care and maintenance with the supply cord connected to a power outlet
can lead to severe injury and burns.
▶ Always unplug the supply cord before carrying out care and maintenance tasks.
Care
•
Carefully remove stubborn dirt from the tool.
•
Clean the air vents carefully with a dry brush.
•
Use only a slightly damp cloth to clean the casing. Do not use cleaning agents containing silicone as
they can attack the plastic parts.
Maintenance
•
Check all visible parts and controls for signs of damage at regular intervals and make sure that they all
function correctly.
•
Do not operate the product if signs of damage are found or if parts malfunction. Have it repaired
immediately by Hilti Service.
•
After cleaning and maintenance, fit all guards or protective devices and check that they function correctly.
To help ensure safe and reliable operation, use only genuine Hilti spare parts and consumables. Spare
parts, consumables and accessories approved by Hilti for use with the product can be found at your
local Hilti Store or online at: www.hilti.group.
6.1
Replacing the supply cord
DANGER
Risk of injury! Risk of electric shock.
▶ The product may be serviced and repaired only by authorized, trained personnel! This personnel must
be specially informed of any possible hazards.
If it is damaged, the supply cord has to be replaced.
Comply with the country-specific regulations for electrical safety.
*2275224*
2
2275224
English
19
Publicidad
