Indel B TB65 DD STEEL Manual De Instrucciones página 32

OFF-SET VALUE
This is the information needed to align the temperature shown on the display with the actual temperature inside the
refrigerated compartment. Each off-set can be adjusted within a range of from -10 to +10.
After running the refrigeration system for a few hours, place a digital thermometer (not supplied) inside the compartment, in
a location where a more accurate temperature is required, and check that the temperature shown on the display coincides
with the temperature shown on the digital thermometer. If the temperature is not the same, the off-sets must be adjusted
in relation to the temperature T you want the inside of the compartment to reach, so that the temperature reading on the
display coincides with the temperature indicated by the thermometer. The following table shows the factory off-set setting
for each temperature range and the adjustment range for changing these settings.
OFF-SET
F1
F2
F3
With the refrigerator switched off, press and hold the SET +  +  buttons at the same time for a few seconds to access
the OFF-SET value adjustment.
Press the  and  buttons number of times to scroll through the three functions (F1-F2-F3) in succession. Once you have
selected the function you wish to change, press the SET button to access the selected OFF-SET value and press the  and
 buttons to change the factory setting, while remaining within the +10°C ÷ -10°C range. Without having to press any other
button to confirm, the display will automatically save the setting and exit programming mode.
MIN/MAX FUNCTION
This function allows the compressor speed to be slowed down to increase operating efficiencies (MIN) or increase the
compressor speed to provide "quick" cool down times (MAX).
The refrigerator is set by default to MAX. To change this setting, press the SET button 3 times. While the indicator light is
flashing, you can pass from one setting to another with the "UP" and "DOWN" buttons. Once the setting is chosen, leave the
indicator light to flash for 3 to 5 seconds, without pressing any buttons, to confirm the choice.
ENERGY SAVING TIPS
Choose a well ventilated installation location which is protected from direct sunlight and allows air to circulate around the
cabinet.
Allow hot food to cool down first before you place it into the cabinet.
Do not open or leave the lid open more often than necessary.
If ice forms on the internal walls or lid defrost the appliance.
Select the desired cabinet temperature in relation to the intended use, avoid setting unnecessarily low temperatures.
30
TEMPERATURE
RANGE
T ≥ -6°C
-12°C ≤ T ≤ -6°C
T ≤ -13°C
TB STEEL DOUBLE DOOR_(DC)_IM_20220601
FACTORY
SETTING
-2°C
-4°C
-2°C
ADJUSTMENT
RANGE
+10°C ÷ -10°C
+10°C ÷ -10°C
+10°C ÷ -10°C