Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
EN
ENGLISH
MACHINE OPERATION
1.
Avoid stopping for a long time with the machine in the
same position and the brooms rotating: this could create
unwanted marks on the floor.
2.
For machine proper operation, the dust filter must be as
clean as possible. Therefore the filter shaker must be
used at regular intervals (every 10 minutes, but this
interval may vary according to the floor conditions),
according to the following procedure.
– Stop the machine and turn the main switch (A, Fig. 4)
to "0".
– To shake the filter, move the filter shaker knob (B) to
the right and then to the left several times.
– Turn the main switch (A) to "I" and start sweeping
again.
NOTE:
When the dust filter is clogged, the machine cannot
collect dust and debris anymore.
CAUTION:
Do not work on wet floors to prevent the dust filter
from being damaged.
3.
The hopper (C, Fig. 4) should be emptied after each
working cycle and whenever it is full.
NOTE:
When the hopper is full, the machine cannot collect
dust and debris anymore.
HOPPER EMPTYING
1.
Stop the machine and turn the main switch (A, Fig. 4) to
"0".
2.
Remove the hopper (C) by using the handles (D) and (E),
then empty it at the waste collection centre.
3.
Install the hopper (C).
4.
The machine is ready to start working again.
NOTE:
The machine cannot operate when the hopper is
removed.
AFTER MACHINE USE
After working, before leaving the machine:
1.
Turn the main switch (A, Fig. 4) to "0".
2.
Turn on the filter shaker with the knob (B).
3.
Empty the hopper (C) (see the procedure in the previous
paragraph).
4.
Lift the side broom (F, Fig. 4) by pulling the lever (G)
backwards and by engaging it to the fastener.
5.
Make sure that the machine cannot move independently.
6.
Charge the battery (see the procedure in Maintenance
chapter).
MACHINE STORAGE
If the machine is not going to be used for more than 30 days,
proceed as follows:
12
1.
Perform the daily maintenance procedures (see the
previous paragraph).
2.
Check that the machine storage area is dry and clean.
3.
Slightly lift the machine so that the skirts, the main broom
and the wheels do not touch the ground.
FIRST PERIOD OF USE
After the first 8 hours, check the machine fastening and
connecting parts for proper tightening, and check the visible
parts for integrity and leakage.
Figure 4
Operator's Manual - BSW 28
Publicidad
Capítulos
Tabla de contenido
