JOCCA 1618 Manual De Instrucciones página 12

22-E
high risk of explosion or fire.
-Do not allow children or disabled persons using a device or touching
an extension cable. Keep them away from your working area.
-Before connecting the appliance to the mains, check that the cable
and plug are in perfect conditions. Also check that the voltage indica-
ted on the appliance is valid for your electrical installation.
-If you detect that the power supply cable, the plug or the adaptor are
damaged or have fallen into water or any other liquid, do not use the
appliance, replace the cable, the plug, or the adaptor. Go directly to
the authorised JOCCA technical service where they will replace it
correctly for you.
-Do not carry a device by a cord neither pull it to disconnect from a
socket. Avoid cord contacting with hot zones, oil and sharp edges.
-Do not immerse the appliance or any part of it in water or any other
liquid.
-If your appliance has been dropped or fallen into water or any other
liquid do not use it or try to repair it. Take it to the JOCCA technical
service.
-For your safety and for the appliance to work correctly, always use
JOCCA spare parts and accessories.
-Please do not use the appliance with wet hands or feet or with bare-
foot.
-Never touch paint output when a device is operating – you can hurt
yourself.
-Do not direct spray painting against animals or people.
-Do not shake a device when it is operating, it can cause splashing.
-Do not leave a device unattended when while operating.
-Do not put into a tank detergents or chemicals, it can cause dama-
ge of a device.
-If you note that a nozzle of painting output is blocked, do not use a
device and unplug it.
-Disorder in workplace increases risk of an accident, it is recommen-
ded to keep in order your working area.
-Avoid body contact with grounded surfaces (for example, pipes,
radiator, electric cookers, refrigerators).
-Unused tools should be stored in a dry, closed place away from
reach of children.
-It will work better and safer respecting rate of indicated voltage.
-Do not use tools or devices connected to too low power supply for
industrial purpose. Do not use tools in case they are not designed for
this work (for example, do not use manual circular saw to cut or prune
trees).
-Do not wear wide dress or jewels, their parts can get stuck while
moving. For external work it is recommended to wear rubber gloves
and shoes with nonslip soles. If you have long hair, collect it.
-Stand firmly on the floor and keep balance at any moment.
-Keep your tools sharp and clean to work better and safer. Read the
maintenance instructions and indications of equipment change.
Check an extension cable periodically and change it if it is damaged.
Keep handles dry and free of oil and grease.
-Before switch it on, ensure that keys and adjusting tools have been
removed.
-Do not carry a device with the finger on a switch while plugged.
Ensure that a switch is in stop position before plug in a device.
-En el exterior, utilice solamente cables de prolongación previstos
para su empleo en el exterior.
-For external work use only extension cables that are intended for
external use.
-Look at your work. Use common sense. Do not operate the tool
while tired.
-Before using a device again, check carefully protective mechanisms
or parts slightly damaged to determine that a device will operates
correctly and perform its intended function. Check correct alignment
and free movements of all the mobile parts or if there are other dama-
ged parts. All the parts must be assembled correctly and qualify to
guarantee faultless operating of a device. Any damaged protective
mechanism or any part must be repaired or replaced appropriately by
authorized service if it is not stated otherwise in the manual.
Damaged switch of a remote control must be replaced by authorized
service. Do not use a device if its switch can not close and open cir-
cuit correctly.
-This tool is in accordance with safety rules in force. Any repairing
must be made by specialist and with original spare parts only – if not,
it can cause serious risk to user's safety.
-Do not use guns to spray inflammable materials.
-Do not clean guns with inflammable solvents.
E-23