Publicidad
3. Location
1. In the picture above, hand controller can
storage and
memorize 3 positions. The memory method is as
memory
follows. When running to a specific point, press
operation
the "S" button, the digital tube displays "S-", and
"-" flashes at the same time, then press the any
button number of "1-3" to store the current
position to the corresponding key.
1. If you want the desktop to reach the
memorized height, you only need to press the
button number. At this time, the digital tube will
display the height memorized at the button
number, and then automatically run to the
corresponding height. When running, any key
can stop the system.
4. Lock and
1. Lock: Press and hold "S" + "UP" at the same
unlock
time for 5 seconds, when the nixie tube displays
"Loc", it means that the system has been locked,
and the system cannot be raised or lowered.
2. Unlock: Press and hold "S" + "DOWN"
simultaneously for 5 seconds, when the digital
tube displays from "Loc" to normal digital display,
it means the system has been unlocked.
5. Factory
When the system is installed in a new electric
reset
desk column, or the parameters need to be
restored to the factory settings, press and hold
"UP+DOWN" simultaneously for 10 seconds to
hear a long buzzer prompt. At this time, the
parameters are restored to the factory setting,
and it is forced to complete initialization.
42
Error code
Error code
Meaning
E01
Mains voltage exceeds
45V
E02
The height deviation
between the screw rods
exceeds 1cm.
E04
Hand controller
connection or
communication error
E05
Stop when encountering
resistance
E06
The main power supply
fails to start, and the
voltage is lower than
20V.
E07
Protection when the
main power supply is
running, I voltage is
lower than 20V
Resolution
Check main power supply
Reinitialize it again
Check hand controller cable
Release the button and
restart
Replace the main power
supply, or check the main
power supply cable
Power on again
43
Publicidad
