Chemical Mixing System Draining; Fuse Check/Replacement; Safety Functions; Emergency Push-Button - Clarke FOCUS II Micro Rider Instrucciones De Uso

ENGLISH

CHEMICAL MIXING SYSTEM DRAINING

(For machines with Chemical Mixing System)
1. To remove the detergent remained in the hoses and in the pump, perform the following procedure.
2. Turn on the machine by turning the ignition key (58) to "I".
3. Press the switch (53). Check that the switch LED (54) turns on.
Press the switches (53 and 59) at the same time, until the switch LED (54) starts flashing (after about 5 seconds).
4.
Release the switches and wait for the LED (54) to stop flashing and for the vacuum system to turn on.
5.
Collect the detergent remaining on the floor.
6.
7. Turn the ignition key (58) to "0".
8. Lift the tank (19), then check that the detergent tank hose (42) is empty, otherwise perform steps 3 to 7 again.
NOTE
As necessary drain the water from the recovery tank (19) through the hose (24).
The draining cycle lasts about 30 seconds, then the vacuum function automatically turns on, which allows the operator to
remove the remaining detergent.
The draining cycle can also be performed with the detergent tank (42) full of water, thus cleaning the system thoroughly.
It is advisable to perform this type of draining to clean the Chemical Mixing System from dirt and deposits if the machine
has not been used/cleaned for a long time.
The draining cycle can also be performed to quickly fill the detergent supply hose when the tank (42) is full but the
system is still empty.
If necessary, the draining cycle can be repeatedly performed.

FUSE CHECK/REPLACEMENT

NOTE
All machine electrical circuits are protected by auto-resettable electronic devices. The safety fuses activate only in case
of serious damage.
It is recommended to have the fuses replaced by qualified personnel only.
Refer to the Service Manual available at any Clarke Retailer.

SAFETY FUNCTIONS

The machine is equipped with the following safety functions.

EMERGENCY PUSH-BUTTON

It is located in an easily accessible position (8). Press it firmly in case of immediate necessity to stop all machine functions.
To reset the machine operation, lift the tank assembly (19) from the left side and reconnect the battery connector (9).

ANTI-SKID SAFETY SYSTEM

This system reduces the speed when turning and when the machine tilts laterally to avoid sudden skids, thus increasing the
machine stability in any condition.

DRIVER'S SEAT MICROSWITCH

It is inside the driver's seat and it prevents machine movement when the operator is not on the seat.

ELECTROMAGNETIC BRAKE

Built into the front wheel and keeps the machine braked when the machine is off or stopped.
26
Operator's Manual - FOCUS II Micro Rider