Publicidad
Idiomas disponibles
Idiomas disponibles
O O p p e e r r a a t t i i n n g g I I n n s s t t r r u u c c t t i i o o n n CORREX
6 6 . . 3 3
C C O O R R R R E E X X
® ®
U U P P 2 2 . . 3 3 - - 9 9 1 1 9 9 s s c c o o p p e e o o f f s s u u p p p p l l y y w w i i t t h h m m o o u u n n t t i i n n g g k k i i t t f f o o r r r r e e t t r r o o f f i i t t t t i i n n g g
The CORREX
alternatively used for:
sleeve mounting
insulated-hole mounting.
Check by comparison with the table below that the parts and components
supplied are complete and that the small bag is intact.
Number
1
1
1
1
1
1
1
1
1
1
1
1
2
1
1
The item numbers of the mounting kit correspond to the numbering in the
annex 'Mounting kits for retrofitting - arrangement of parts'
N N o o t t e e : : The mounting kit for sleeve mounting requires prefitting of the screw fit-
ting set in acc. with chapter 7.1.2.1. The mounting kit for insulated hole moun-
ting is used as described in chapter 7.2.2.
30
®
UP 2.3-919
®
UP 2.3-919 system with mounting kit for retrofitting can be
Item
Description
Titanium anode with thread bolt and seal washer
Plug-in potentiostat with pilot lamp
Connecting cables with connectors
Mounting kit in small bag containing:
1
Seal
2a
Screw fitting G ¾"
2b
Screw fitting G 1"
2c
Screw fitting G 1¼"
3
Insulation sleeve, small
4
Insulation sleeve, large
5
Diode board
6
Tooth lock washer with tab connector
7,8
Nut M8, galvanized
9
Flat nut M8, galvanized
Operating Instructions
Publicidad
