Xylem JABSCO 62040-4 Serie Manual De Instrucciones página 2

Models 62040-4 Series, 62042-4 Series
FEATURES
• Complete drive unit enclosed in light housing.
• Single control lever for vertical and horizontal movement.
• On-off Spot only on 7" and 8"models.
• Exclusive Clutch-A-Matic feature protects drive unit against
overload. Can operate for extended periods against limit stops
without harm. Light head may be moved manually without
damage to the drive unit.
• Internal brake system holds beam firmly on target.
• Includes control with on-off, and single control for vertical and
horizontal movement.
Model
Volts
Number
62040-4002 12
62040-4006 24
62042-4006 24
CABLE LISTING
Part Number
43990-0013
43990-0014
43990-0015
43990-0016
LIGHT MOUNTING
See base mounting dimensions for appropriate model light.
Mount all models with front of base toward direction of most
intended use (front of circular base is marked with arrow). Drill
screw holes (per dimensional drawing) and a 1-1/8" (28mm) hole
at center of base for wiring cable. Drill additional holes for wiring
cable through firewalls, bulkheads, etc., for connection to control.
With gasket under light base, feed wire through hole and fasten
light in place.
NOTE: Cable connectors are provided for easy wiring connections.
See Wiring Diagram.
CONTROL MOUNTING
43670-0003 12 VOLT & 60070-0000 24 VOLT
Select a location near the helm which will allow convenient
operation of control. Unit may be mounted on vertical, horizontal
or inclined panel.
1. Cut 2-5/8" (67mm) diameter hole in flat surface where control
is to be mounted.
2. Route power leads (supplied by customer) from power source
to control. NOTE: Wiring must be 16 gauge with maximum
run of 15 ft.
Bulb
Head Base
Type
Brass Brass 7" Spot
Brass Brass 7" Spot
Brass Brass 8" Spot
Description
10' Cable Assembly
15' Cable Assembly
25' Cable Assembly
35' Cable Assembly
Candlepower
(Combined)
230,000
230,000
500,000
CONTROLS
Part Number
43670-0003
43670-0004
60070-0000
18753-0335
3. Crimp terminals supplied onto power leads. NOTE: Larger
terminal is crimped to positive lead – smaller terminal to
negative lead.
4. Insert wiring cable and power leads thru back of hole and plug
into control.
5. Use bedding compound or sealant to waterproof control
mounting.
6. Secure control with self-tapping screws provided.
CIRCUIT PROTECTION
Two (2) automotive type fuses are included in the control. One
(10 amp) protects the bulb circuit, the other (3 amp) protects the
motor circuit.
Fuse
2
Description
Primary Control 12 V
Secondary Control Kit 12 V
Primary Control 24 V
Secondary Control Kit 24 V
Fuse