Publicidad
Idiomas disponibles
Idiomas disponibles
Usinga
screwdriver,
tightenthe
screw.
CAUTION
Do not overtighten.
Overtightening
could strip the
screw holes.
Do not operate the cleaner without
the screw in place.
CORD ASSEMBLY
Make sure the quick release
upper cord
hook is in the upright position.
Remove
the wire tie from the power cord.
Lock the cord
into place by
forcing it into the
locking notch on
the body of the
quick release
upper cord hook
as shown_ This
helps keep the
power cord out
from under the
vacuum
cleaner
agitator.
Lock#
Power
Wrap the power cord around the upper
and lower cord hooks and lock the power
cord plug onto the power cord.
Uppe_ Cord
Hook
Power
Cord
Lower
Cord
HOW TO START
] F _Qulck
Release
"_
Upper Cord
1. Turn the
quick
release
upper cord
hook to
either side
and down to
release
the
power cord..
2. Release
the power cord plug from the
power cord and pull the cord off the quick
release upper cord hook. Check to be
sure the power cord is still locked into the
lock in the quick release
upper cord hook.
3. Check to see if the cleaner has bag
installed. See DUST BAG CHANGING,,
NOTE; To reduce the risk of electric
shock, this vacuum cleaner has a polar-
ized plug, one blade is wider than the
other, This plug will fit in a polarized
outlet
only one way. If the plug does not fit fully
in the outlet, reverse the plugo If it still
does not fit, contact a qualified
technician
to install the proper outlet. Do not change
the plug in any way.
4, Plug the polarized
power cord into a
I20 Volt outlet located near the floor.
Personal
Injury and Product Damage
Hazard
• DO NOT plug in if switch is in the ON
position.
Personal injury or damage
could result.
• DO NOT use outlets above coun-
ters. Damage from cord to items in
surrounding
area could occur.
Publicidad
