Kärcher B 300 RI BP Manual Del Usuario página 52

5.3 Removing the transport lock from the suction bar
5.4 General information
5.5 Daily before starting operations
52
The suction bar is locked with a transport lock when
the device is delivered.
Cut the cable tape

Remove the red safety clip.

Keep the safety clip, it is needed when transporting the

device.
See chapter "Securing the vehicle"
Before initial start-up, read the operating instructions

and observe the safety instructions contained therein!
Park the device on a level surface and always secure it

against rolling away (lock the parking brake).
Always remove the ignition key when leaving the vehi-

cle.
WARNING
Risk of injury!
Side brushes as well as brushes in the brush head and
scrubbing deck can rotate unintentionally. Always switch
off the device and remove the ignition key when working in
this area. Never reach into the brush head when the vehi-
cle is operating.
Check the battery charge level and recharge the bat-

tery if necessary.
Check the hydraulic oil level.

Empty waste container.

Empty the waste water tank.

Fill fresh water tank as needed.

Check brushes for wear and damage.

Check suction lip of the suction bar for wear and dam-

age.
Check/clean the water and suction system.

Check function of all operator control elements.

Check appliance for damages.

Clean the dust filter with the filter cleaning button.

Note: For description, see section on Care and mainte-
nance.
14
-
EN