Antar AT52315 Manual De Usuario página 7

NOTE: THE PHOTOS USED TO PRESENT THE FUNCTION OF THE WHEELCHAIR ARE FOR ILLUSTRATIVE PURPOSES ONLY, THEY MAY DIFFER FROM
THE ACTUAL APPEARANCE OF THE PRODUCT.
DISPLAY
The wheelchair is unfolded by extending the seat outwards, then pressing the seat down at the sides with both hands until it is completely
unfolded. Next, unfold the backrest and attach e its corresponding holes to the top of the backrest. Finally, attach the head cushion with
Velcro.
(Fig.1 and 2)
FIG. 1 FIG. 2
SUBMISSION
To fold the wheelchair for transport, remove the high backrest and fold down the lower backrest. Grasp the centre of the seat and then lift it
upwards to fold the wheelchair. (Figures 6 and 7) To fold the wheelchair completely, start by removing the footrests and then follow the steps
described above.
FIG. 6 FIG. 7
FOOTSTOOLS
To fit the footrests, place them in the appropriate holes and turn them inwards so that they lock into the correct position. (fig. 8). Once fitted,
check the stability of the footrests by pulling. To remove the footrests, pull the handle backwards (fig. 9), then turn the footrest towards the
outside and pull out the footrest. To remove the footrest, lift it up. (Fig. 10)
FIG. 8
FOOTREST ANGLE ADJUSTMENT
To adjust the desired angle, raise the footrest by gripping the metal tube from underneath(Fig. 11). If you need to adjust downwards, press the
adjustment lever (Fig. 12) Once you have set the correct leg position, release the adjustment lever. (Fig. 13).
FIG. 11 FIG.12
HEIGHT ADJUSTMENT OF THE FOOTRESTS
Loosen the screw located at the footrest plate with a hex key, remove the screw, adjust the height of the footrest and then tighten the screw (Fig.
10 and 11). It is also possible to adjust the height of the calf support - 3 steps of adjustment. (Fig. 12).
FIG. 10 FIG. 11
IU_AT52315
FIG. 3
FIG. 9 FIG. 10
FIG.13
FIG. 12
FIG. 4 FIG. 5