airhood AH-01BE Manual Del Usuario página 5

CLEANING AND CARE
Note
■ Do not use solvents, chemical or abrasive cleaning agents, wire brushes, sharp
objects or scouring pads to clean the AirHood.
■ Never immerse the AirHood main body, charger/power cord in water.
The AirHood is designed to make cleaning quick and easy. To keep your AirHood in tip top
condition, we recommend that you clean the main unit and the front filter after each use and
change the rear filter after every 100 hours of use.
1. Make sure the power switch is in the off position O and that the AirHood is disconnected
from the power supply.
2. The air duct is fixed into place with magnets. Simply pull the tab on the top of the air
duct to release and remove it. Similarly, pull the tab on the air diffuser on the back of the
AirHood and remove it.
3. The front filter is attached to the back of the air duct. It comprises 2 parts, the stainless
steel mesh and the frame that holds the mesh in place. Turn the front filter frame
anticlockwise to remove it from the air duct. Then, pop out the wire mesh.
TIP: When reassembling the front filter, make sure you put the mesh into the front filter
frame, align the frame with the groves on the air duct and then twist the front filter frame
clockwise until the two parts slot firmly together.
If the rear filter becomes a bit wet (this may happen when it is used for filtering
water vapor), remove the rear filter and let it dry naturally away from the AirHood.
We recommend that you also check the front filter for moisture and if necessary dry
it with a towel. Only reassemble when both filters are completely dry.
2 3
5
2
8 | EN | Airhood (AH-01BE)
4
4. If it is time to change the rear filter, lift out the old one and replace after cleaning the main body.
TIP: When you handle the rear filter, you may see some carbon / charcoal residues
(little black specks), this is normal and does not mean that the rear filter is degrading.
When inserting a new filter. Make sure the filter is tucked behind the two clips that hold
it in place.
5. Clean the main body with a damp soft cloth.
6. Clean the air duct, front filter and air diffuser using a mild detergent and soft cloth.
Only the front filter is dishwasher safe. Do not put any other parts in a dishwasher.
7. Dry all parts thoroughly and reassemble the AirHood.
STORAGE INSTRUCTIONS
■ If you are not using the AirHood for a long period, always clean and store it in its original
packaging in a dust-free, dry environment.
TROUBLESHOOTING
MALFUNCTION CAUSE
The AirHood Power supply issues.
is not working.
The AirHood The setting is too low.
doesn't appear
to be working
optimally.
The AirHood is dirty
and/or the rear filter
needs changing.
REMEDY
Connect the charger making sure it is firmly
connected to the charging socket and the
mains socket. Check the battery level and
charge as required.
Try a higher setting.
Clean the unit as described in the
CLEANING AND CARE section and/or
change the rear filter if it is clogged or
has been used for 100 hours.
Airhood (AH-01BE) | EN | 9