Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
Instructions
265 VOLT ELECTRICAL SUPPLY
[] ATTACH CONDUIT
1 Use the romM
knockout
at the botton/oI
the
junction
box to attach
conduit
coming
fl'om the
branch
circuit.
Remove
the knockout,
attach the
conduit
and bring wires into tlm jtmction
box.
i,eave 6" ot wire flee at the end of the conduit
to allow connections
to be made.
2 If a fllse and fllseholder
are to be used, the
knockout
at the top of the box is for n/ounfing
a Buss Fuseholde_:
Be sm'e the filse and filseholder
are of the same rating as the branch
circuit.
I,eadwires
at the fi/se can be either
soldered
in
place or attached
using UL-listed
1/4" female
(receptacle)
crimp connectors.
[] REINSTALL JUNCTION
BOX
• Reinstall
the jtmction
box by engaging
the left tabs
on the lower right tace ot the trait, aligning
the
screw holes at the top and bottom
and driving
the
two screws tmfil secm'e.
Be sm'e that all wire leads
are inside the box and not pinched
between
the box
and the trait. The green
insulated
ground
wire fl'om
the trait MUSTbe
com_ected
to the branch
circuit
grotmd
wire.
Make all wire connections
by using approl)riate
UIAisted
electrical
com_ectms
and mchniques
(black U) black, white U) white and green
to green).
[] REINSTALL JUNCTION
BOX COVER
1 Careflflly rock all wires and connections
back inside
thejm_ction
box. Be sm'e there are no loose
connections
or stray tminsulated
wires exposed.
2 Place thejm_cfion
box cover in place. Replace
the
two scre_vs removed
earlier
and tighten
seem'ely.
3 Discard
the mmsed
portion
of the plug and
the cordset.
16
Publicidad
