Lenco LS-470 Manual De Usuario página 10

Turntable Platter and Belt Setup
1. Turn the platter over and check the belt position.
Make sure that the drive
belt is looped in the middle
of the circle. The drive belt
located too high or too low
in this circle may cause the
drive belt to fall off or speed
to be unstable.
2. Set the platter on the spindle.
Make sure the platter is fully seated on the spindle.
Opening
Spindle
3. Place the belt on the motor pulley.
Align one of the platter openings with the motor pulley, and while
pulling both ends of the red ribbon that comes attached to the belt,
place the belt on the motor pulley, as per the diagram. When doing this,
be careful not to twist the belt.
Hook
Belt
Platter
Motor pulley
Straight Twisted Wrong location
Motor Pulley
10