Num'axes PIE1067 Manual De Instrucciones página 33

7. Operation
7.1. Turn ON the camera
Put the switch in the ON position; the camera is ready to work.
The camera status LED located on the front will blink and count down 5 seconds. This
interval allows you time to close the camera front cover and leave the monitored
area.
Once in the ON mode, the camera will take photos and/or videos according to its
current parameter settings.
NOTE: the camera comes pre-programmed with factory default settings. So, for test
purpose, you only need to insert the memory card and AA batteries then power on
the camera (switch in the ON position).
7.2. Turn OFF the camera
Slide the switch to the OFF position to turn off the camera. Please note that even in
OFF mode, the camera still consumes power at a very low level. Therefore, please
remove the batteries if the camera will not be used for a long time period.
The OFF mode is the "safe mode" for actions such as: replacing the memory card or
batteries, or transporting the camera.
Guide PIE1067 – Février 2024 – ind. A - 33/128