Num'axes PIE1067 Manual De Instrucciones página 37

IR flash power
Time Lapse
PIR interval
In high temperature environment, subjects body
heat and environment temperature are hard to tell
by the camera, the suggested setting is high.
However, it is recommended to use low PIR
sensitivity
interference like hot wind, smoke, near window,
etc. This will prevent untimely triggering.
High | Low
This parameter allows you to adjust the brightness
of the infrared flash.
ON | OFF
With Time Lapse set to ON, the camera will capture
photos or videos automatically at a pre-set time
interval regardless of whether motions are
detected or not.
WARNING: when the Time Lapse parameter is set
to ON, the PIR sensor is deactivated (there is no
motion detection).
Select ON to set the Time Lapse; the camera will
shoot photos or video clips automatically upon the
set interval.
Configurable Time Lapse: from 00:00:05 to
23:59:59
Example: if Time Lapse is set to 00:30:00, the
camera will automatically capture photos/videos
every 30 minutes.
ON – default: 20 seconds | OFF
Select ON to set the time interval that you desire
between photos/videos upon motion. This option
avoids camera taking to many photos or videos.
Configurable PIR Interval: from 00:00:05 to
23:59:59
Example: if the PIR interval is 00:01:00, the camera
will wait 1 minute between photo/video recordings
with motion.
Guide PIE1067 – Février 2024 – ind. A - 37/128
in environments with lots of