Publicidad
Idiomas disponibles
Idiomas disponibles
Figure
35
OPERATING
THE MORTISER
Figure
37
D_
4.
To remove the extension (D). pUacea 16mm open
end wrench (not provided) on the flats of the exten-
sion. See Figure 35.
5.
Insert a fiat head screwdriver into the center hoUeof
the motor end cap.
6.
Turn the wrench clockwise to Uoosen the extension
from the motor shaft.
7.
Unscrew the extension from the motor shaft and
remove.
Figure
36
1.
Make sure that the workpiece (A) is heUdfirmUy
against the fence (B) when cutting and that the
hoUddown (C) is propedy adjusted.
See Figure 37.
2.
Using the Raise/Lower handUe (D), Uower the chiseU
until it penetrates the workpiece.
NOTE:
The rate of penetration of the chiseU must be
fast enough to prevent burning at the tip of the bit, but
not too fast as to staff the motor.
NOTE: You may encounter smoke from the bit or
matedaU once the chiseU has engaged the material.
The smoke created is a natural operating occurrence in
hollow chisel mortising and is caused by material chip
friction and the resins in the stock being burned off.
8.
Thread the chuck onto the motor shaft and tighten.
See Figure 36.
22
Publicidad
