Uline H-3133U-12 Manual Del Usuario página 2

Diagram 1
L1
Single Hole
L1
Double Hole
FRAME
NOTE: DO NOT tighten bolts until instructed.
IMPORTANT! Back panel (F) has both round
and slotted holes. The round holes are at the
bottom, and the slotted holes are at the top (L1).
1. Place the ladder stile (D) on the floor. Be sure to
assemble on a protective surface so the finish
does not get damaged. (See Diagram 1)
2. Using six 3/8-16 x 1¼" hex head cap screws and
self-locking nuts, bolt the top (slotted holes) of
back panel (F) to the insides of L1. (See Diagram 1)
3. Bolt the bottom (round holes) of back panel (F)
and back of base panel (E) on the insides of L2.
(See Diagram 1)
4. Bolt the front of base panel (E) to the insides
of L3. (See Diagarm 1)
PAGE 2 OF 9
L1
Model
Model
ASSEMBLY
G
F
D
H
E
L5
L4
L2
HORIZONTAL AND VERTICAL BRACES
NOTE: DO NOT tighten bolts until instructed.
1. Place horizontal brace (G) on the outside of L4 and
L5. (See Diagram 1)
2. Place vertical brace (H) on the outside of L4 and L6.
(See Diagram 1)
3. Secure horizontal and vertical braces to frame
using three 3/8-16 x 1¼" hex head cap screws and
three self-locking nuts at L4, L5 and L6.
(See Diagram 1)
4. Repeat for opposite side.
WARNING! Never climb a ladder that is not
completely assembled.
L3
Single Hole
Model
L3
L6
Double Hole
Model
L3
1223 IH-3133U-12