Publicidad
Idiomas disponibles
Idiomas disponibles
Diagram 2
C
Step 3
Rear
Handrail
Bar
HANDRAIL INSALLATION
NOTE: DO NOT tighten bolts until instructed.
1.
With ladder on its side, install handrail (A) into
the rear stairway tubes. Use the rubber mallet as
needed for mating parts. (See Diagram 2, Step 1)
2. Detach handrail brackets that are shipped attached
to handrails.
3. Clamp side handrails to outside of stairway tubes
using handrail brackets and 3/8-16 x 2" hex head
cap screws, gray bushings and self-locking nuts.
(See Diagram 2, Step 2)
4. Repeat step 3 with side handrail (B).
REAR HANDRAIL BAR INSTALLATION
1.
Detach rear handrail bar (C) that is taped to the
handrail.
2. Insert notched bushing into each end of rear
handrail bars (C). (See Diagram 2, Step 3)
3. Position rear handrail bar between holes on the
top part of side handrails using four 1/4-20 x 2¾"
hex head cap screws. (See Diagram 2, Step 3)
4. Tighten all handrail bolts.
PAGE 3 OF 9
ASSEMBLY CONTINUED
1/4-20 x 2¾"
H.H.C.S.
Tube Cap
Handrail
Side
Handrail
Rear Stile
Tube
Notched
Bushing
Step 1
1-800-295-5510
uline.com
Stile
Tube
A, B
Step 2
D
LEVELING
1.
Stand ladder upright on level surface.
2. Activate safelock by stepping on the trip bar
located in front of the first step.
NOTE: This sets the ladder on the feet to level.
3. When steps are level, tighten all installed bolts.
NOTE: Do not proceed until ladder is stable.
Handrail
Handrail
Bracket
3/8-16
Self-locking
Nut
Gray
Bushing
3/8-16 x 2"
H.H.C.S.
Trip Bar
1223 IH-3133U-12
Publicidad
