DeWalt DCD991 Manual De Instrucciones página 15

LOW BATTERY WARNING
When in spotlight mode and the battery is nearing complete discharge,
the spotlight will flash twice and then dim. After two minutes, the
battery will be completely discharged and the drill will immediately shut
down. At this point, replace with a fresh battery.
WARNING: To reduce the risk of injury, always have a back-up
battery or secondary lighting available if the situation warrants it.
Keyless Single Sleeve Chuck (Fig. 7–9)
WARNING: Do not attempt to tighten drill bits (or any other
accessory) by gripping the front part of the chuck and turning the
tool on. Damage to the chuck and personal injury may result. Always
lock off trigger switch and disconnect tool from power source when
changing acces sories.
WARNING: Always ensure the bit is secure before starting the tool.
A loose bit may eject from tool causing possible personal injury.
Your tool features a keyless chuck with one rotating sleeve for one-
handed operation of the chuck. To insert a drill bit or other accessory,
follow these steps.
1. Turn tool off and disconnect tool from power source.
2. Grasp the black sleeve of the chuck (D) with one hand and use
the other hand to secure the tool as shown in Figure 7. Rotate the
sleeve counterclockwise (as viewed from the front) far enough to
accept the desired accessory.
3. Insert the accessory about 3/4" (19 mm) into the chuck and
tighten securely by rotating the chuck sleeve clockwise with one
hand while holding the tool with the other hand. Continue to rotate
the chuck sleeve until several ratchet clicks are heard to ensure full
gripping power.
Be sure to tighten chuck with one hand on the chuck sleeve and one
hand holding the tool for maximum tightness.
To release the accessory, repeat Steps 1 and 2 above.
FIG. 7 FIG. 8
D
Belt Hook and Bit Clip (Optional Accessory,
Fig. 2)
WARNING: To reduce the risk of serious personal injury,
turn tool off and remove the battery pack before making any
adjustments or removing/installing attachments or accessories.
An accidental start-up can cause injury.
WARNING: To reduce the risk of serious personal injury,
ONLY use the tool's belt hook to hang the tool from a work
belt. DO NOT use the belt hook for tethering or securing the tool to
a person or object during use. DO NOT suspend tool overhead or
suspend objects from the belt hook.
WARNING: To reduce the risk of serious personal injury,
ensure the screw holding the belt hook is secure.
CAUTION: To reduce the risk of personal injury or damage,
DO NOT use the belt hook to hang the drill while using as a
spotlight.
IMPORTANT: When attaching or replacing the belt hook (J) or bit clip
(K), use only the screw (L) that is provided. Be sure to securely tighten
the screw.
12
FIG. 9