Attach the spray bottle and wiper
attachment and fill it with detergent
Note: Please note that after first activation
of the spray head transport lock will loosen.
Attach the wiping attachment
Illustration
Remove the spray head from the spray
bottle.
Attach the wiper attachment to the
spray head.
Secure the wiper attachment and the
spray head with the fixating ring.
Illustration
Attach the wiper pad to the wiper at-
tachment and secure with Velcro.
Fill the spray bottle
Illustration
Fill the included concentrate (1 x 20 ml)
into the spray bottle and fill the bottle
slowly with clear water (makes 250 ml
of detergent solution).
Close the bottle.
Charge the battery
Illustration
Insert the charger delivered with the ap-
pliance into a proper socket.
Insert the charging cable plug to the
back of the appliance.
Note: During the charging process, the
charge/operating display blinks. Once
the battery is fully charged, it will be per-
manently illuminated.
10
Cleaning with spray bottle and wiper
attachment
Illustration
Press the spray lever on the bottle to
apply the detergent and spray the sur-
face evenly; after that, loosen the dirt
using the wiping pad.
Note: Rinse pad under running water if
needed!
Illustration
Switch the appliance on, the charge/op-
erations display will illuminate.
Important: Prior to use, ensure that the
squeegees are free of soiling.
Pull the appliance from the top to the
bottom to vacuum up the detergent.
Note: Hard to reach areas can be vacu-
umed vertically or horizontally (limited
areas).
Notes:
If the battery is low, the charging / power in-
dicator starts flashing slowly and the appli-
ance switches off after a certain time. If this
is the case, charge the battery.
The appliance can be switched off while the
spray bottle is in use. This significantly in-
creases the operating time per battery
charge.
Cleaning without the spray bottle
Apply the detergent as usual according
to manufacturer's instructions and loos-
en the dirt.
Further procedure same as the "Clean-
ing with spray bottle and wiper attach-
ment", see illustration
– 5
EN
Start working
.