Publicidad
Idiomas disponibles
Idiomas disponibles
1.
Loosen the two screws while holding the outer
sleeve. The outer and inner sleeves will be pushed up
by the springs built into the tool.
Fig.6
► 1 . Outer sleeve 2. Screw
2.
Press the pin down to remove the inner sleeve
from the outer sleeve.
Fig.7
► 1 . Inner sleeve 2. Pin 3. Outer sleeve
NOTICE:
Be careful not to drop the inner sleeve
when removing it.
NOTICE:
Do not remove the tip rod, tip rod
spring, and inner sleeve spring from the tool.
Fig.8
► 1 . Tip rod 2. Tip rod spring 3. Inner sleeve spring
Installing the outer and inner
sleeves
1
Place the inner sleeve with the pin facing upward.
Attach the outer sleeve to the inner sleeve securely
while pressing the pin of the inner sleeve.
2
Fig.9
► 1 . Outer sleeve 2. Pin 3. Inner sleeve
1
Insert the outer and inner sleeves into the tool while
rotating the inner sleeve clockwise and counterclock-
wise until the outer sleeve touches the tool. Tighten the
2
two screws firmly.
3
1
2
3
Fig.10
► 1 . Outer sleeve 2. Screw
NOTICE:
the outer sleeve and the tool.
8 ENGLISH
2
Make sure that there is no gap between
1
2
3
1
Publicidad
