Publicidad
Idiomas disponibles
Idiomas disponibles
CHARCOAL
WATER FILTER
INSERTING THE WATER FILTER
1. Remove the filter from the polybag and
soak, fully immersed, in cold tap water
for 15 minutes.
2. Lift the water filter holder out of the water
reservoir on the 10-cup coffeemaker side.
3. Press down on the filter compartment and
pull toward you to open.
4. Place the filter into the holder and snap
closed. Be careful: Improper placement can
tear the filter skin.
5. Flush the filter by running cold tap water
through the holes in the bottom of the
compartment for 10 seconds.
6. Allow the filter to drain completely.
7. Slide the water filter holder back into the
channel in the water reservoir, pushing
down to the base of the unit.
NOTE: Repeat steps 1-7 above on the
single-serve side.
NOTE: We recommend changing the water
filter every 60 days or after 60 uses, and more
often if you have hard water.
Replacement filters can be purchased in stores,
by calling Cuisinart Consumer Service, or at
www.cuisinart.com.
SETTING UP YOUR
10-CUP COFFEEMAKER
INITIAL CLEANING
Perform an initial cleaning before making
your first beverage. Follow these
instructions, without adding coffee.
1. Insert charcoal water filter if you haven't
already. Instructions at left.
2. Fill the water reservoir.
3. Make sure the carafe is in place.
4. If you haven't already, plug the power
cord into an independent outlet.
5. Turn the function knob to BREW.
6. Press the BREW/OFF button and allow
brew cycle to run.
7. The one-time cleaning process is
complete. Discard the hot water. Your
coffeemaker is ready to use.
PROGRAMMING YOUR
10-CUP COFFEEMAKER
SETTING THE CLOCK
When the coffeemaker is plugged in, 12:00 will
flash.
Turn the function knob to CLOCK
Press HR and MIN buttons to select
the desired time. If 12:00 stops flashing,
simply press and hold the HR or MIN button
to return to flashing Time Set mode. Hold
buttons down to scroll through the digits,
or press and release to advance one digit at a
time. When scrolling, the numbers will advance
slowly and then speed up. When the number
displayed approaches the desired time, press
and release to advance one digit at a time.
Be sure the PM indicator is on if a PM time
is desired.
To finish setting the clock, turn the function
knob to any other setting or simply wait until
the numbers stop blinking.
9
Publicidad
