Publicidad
Idiomas disponibles
Idiomas disponibles
NOTE: The information contained in this Manual is designed to assist you in the safe maintenance of the Nailer.
Some illustrations in this Manual may show details or attachments that diff er from those on your own Nailer.
MAINTENANCE AND INSPECTION
Read section titled "SAFETY" (pages 4 – 8).
● Disconnect air hose and remove all nails
from Nailer when:
1) doing maintenance and inspection; and
2) clearing a jam.
1. Clearing a jam
Remove a jammed nail in the following order:
1 DISCONNECT AIR HOSE.
2 Remove all nails.
3 Release the lock lever and open guide plate (A).
4 Remove the jammed nail with a slotted-head
screwdriver.
5 Close guide plate (A) and latch.
6 In case of frequent jam, contact a metabo HPT
authorized service center.
3
Lock lever
3
Guide plate
2. Inspecting the magazine.
1 DISCONNECT AIR HOSE.
2 Clean the magazine. Remove dust which may
have accumulated in the magazine.
3 Lubricate the nail rail with metabo HPT pneumatic
tool lubricant.
MAINTENANCE
WARNING
1 Disconnect
air hose
4
3
Nail rail
3. Storing
○ When not in use for an extended period, apply a thin
coat of the lubricant to the steel parts to avoid rust.
○ Do not store the Nailer in a cold weather environment.
Keep the Nailer in a warm area.
○ When not in use, the Nailer should be stored in a
warm and dry place.
Keep out of reach of children.
4. WARNING LABEL
Do not use the Nailer with missing or damaged
WARNING LABEL.
A new WARNING LABEL is available from a
metabo HPT authorized service center.
Warning
label
5. Maintenance chart (See page 20)
6. Operator troubleshooting (See page 21)
7. Service parts list
A: Item No.
B: Code No.
C: No. Used
D: Remarks
CAUTION
Repair, modifi cation and inspection of metabo HPT
Power Tools must be carried out by a metabo HPT
Authorized Service Center.
This Parts List will be helpful if presented with the tool
to the metabo HPT Authorized Service Center when
requesting repair or other maintenance.
English
1 Disconnect
air hose
Warning
label
19
Publicidad
