Publicidad
Idiomas disponibles
Idiomas disponibles
Once connected to 2.4ghz wifi and with bluetooth enabled, open
Energeeks 3.0 and follow the steps below:
•
Insert the batteries into the sensor, then keep the reset button
on the sensor pressed for approximately 5 seconds, until the led
indicator begins to flash rapidly.
•
In the application, press the "+" in the upper right corner and select
"add device".
•
The app will detect the sensor automatically, so press the red
"add" button and follow the instructions of the app.
If the application does not detect the sensor, it may be because the
device is not in installation mode (the led flashing rapidly), or because
bluetooth is not activated. Please fix it and try again or continue with
the EZ installation.
EZ Installation (Easy Mode)
Once connected to the 2.4ghz Wi-Fi, open Energeeks 3.0 and follow
the steps below:
•
In the application, press the "+" in the upper right corner and
select "add device".
•
Select "Smart Alarm System" and follow the instructions of
the application.
20
Publicidad
