Publicidad
Idiomas disponibles
Idiomas disponibles
NOTE: The automatic start up timer can also be initiated from the keychain transmitter.
To do this:
1. Start the vehicle using the keychain transmitter by pressing and releasing the
second channel transmitter button 2 times.
2. Shut off the vehicle using the keychain transmitter by pressing and releasing the second
channel transmitter button 2 times.
3. Within 10 seconds of step 2, activate the RF start command two times.
(Push the Key button of your keychain transmitter 4 times).
The parking lights will flash and the horn will chirp 2 times to indicate a 2 hour start interval, or 4 times to
indicate a 4 hour start interval. The 2 or 4 hour start sequence is selected at time of installation during the
feature setting mode. Please consult with your installation center if you wish to have this interval changed.
CANCELING THE AUTOMATIC START UP TIMER
To cancel the automatic start up timer do one of the following:
1. Start the vehicle manually with the use of the ignition key and depress the brake pedal.
2. Remote start the vehicle using your RF keychain transmitter.
PROGRAMMING TRANSMITTERS:
At times it may become necessary to program replacement or additional transmitters for use with your
system. To do this:
1. Enter the vehicle and turn the ignition key to the on position.
2. Press and release the Program/Override push-button switch three times. The unit will flash the parking
lights and or beep the horn once to indicate that the system is in the transmitter program mode. The
LED will also flash one time pause, one time pause, etc... indicating that you are in the transmitter
program mode of the unit's channel 1 or single button program mode.
3. Press and hold the key button of the transmitter you wish to operate your system until the parking lights
flash or a beep tone is heard. Repeat this for each additional transmitter you wish to program.
NOTE:
The unit is capable of storing up to 4 transmitters. If a fifth transmitter is added, the first
transmitter programmed will be bumped out.
Once all transmitter have been programmed, turn the ignition switch off to exit the program mode.
By completing the above, the key button of the transmitter will allow you to start the vehicle from the maximum
operating range and also activate the car finder mode.
CAR FINDER MODE:
To activate the car finder mode, press and hold the transmitter button for about 3 seconds. The parking lights
will begin to flash, and horn, if connected, will begin to beep. this will continue for 30 seconds or until you
press and hold the transmitter button for 3 seconds again.
DELETING TRANSMITTERS FROM YOUR SYSTEM:
It may be necessary to delete a lost transmitter or to reprioritize a transmitter that is programmed to your
system. To remove a transmitter that has been programmed in your system:
1. Enter the transmitter program mode of channel 1 as indicated above.
2. Alternately press and hold the transmitter button of each transmitter you wish to remain in the system's
memory until all 4 transmitter slots are full.
NOTE:
For this procedure, you must have all transmitters you wish to remain programmed in your
system available.
If you are uncomfortable about the programming of additional transmitters as outlined in the processes
above please contact your installation center or call the technical service number listed on the back of the
transmitter for help.
2
128-9238
2 of 8
Publicidad
