Publicidad
Idiomas disponibles
Idiomas disponibles
BATTERY REPLACEMENT
The transmitter incorporates a small LED visible through the case which is used to indicate battery
condition. You will notice a decrease in transmitter range as the battery condition deteriorates.
Transmitter battery replacement is recommended at least every 10 to 12 months, depending upon how
frequently the transmitter is used.
To replace the battery in the PN1 Transmitter:
1.
Carefully Separate the transmitter case using the edge of
a coin as shown.
2.
Remove the rear cover to access the discharged battery
paying attention to the proper polarity orientation.
3.
Carefully remove and properly dispose of the discharged
battery.
4.
Insert the new battery, than carefully snap closed the
transmitter case.
5.
If you accidently dislodge the circuit board from the
transmitter housing, be certain that the rubber membrane
is seated properly, and the buttons are properly exposed
from the front view of the case, then insert the circuit
board, and return to step #4.
PN1 Uses 2 x CR2016 Lithium Battery
3
128-9238
3 of 8
Publicidad
