Before Starting Work; Preparing The Backpack Battery For Operation; Charging The Backpack Battery; Setting Up The Charger - Stihl AR 1000 Manual De Instrucciones

English

7 Before Starting Work

7.1

Preparing the Backpack Battery for Operation

Before starting work:
► Check the battery status, @ 9.1.
► Fully charge the battery, @ 8.2.
► Clean the battery, @ 17.1.
► Clean the contact surfaces on the connecting cord,
@ 17.2.
► Position the connecting cord, @ 11.1.

8 Charging the Backpack Battery

8.1

Setting up the Charger

WARNING
Read and follow the safety precautions on the battery and
charger and the warnings and instructions in this manual,
@ 5.1, and in the charger's manual. To reduce the risk of
short circuit, which could lead to electric shock, fire and
explosion, make sure the charger and its components are
dry and not damaged; operate the charger indoors at an
appropriate ambient temperature.
WARNING
A typical household electric circuit is between 15 and 20
amps. A single STIHL AL 500 charger draws approximately
4.8 amps. A single AL 300 charger draws approximately
4.4 amps. To reduce the risk of fire from overloading an
electrical circuit:
► Ensure the electrical system is rated to withstand the
expected electrical draw before charging your battery.
► Charge multiple batteries one at a time or on separate
circuits, unless you know your circuit can handle the total
expected draw from multiple chargers.
10
WARNING
Since the charger heats up during the charging process, do
not operate the charger on a combustible surface or in a
location where combustible gases, liquids, vapors, dusts or
other materials and substances are present.
To set up the charger:
1
► Insert the plug (3) into a properly installed wall outlet (4)
matching the voltage and electrical frequency stated on
the rating plate on the charger.
The charger runs a self-test immediately after it is plugged
in. The charger LED (1) will glow green for about 1 second,
then it will glow red briefly before going out. Once the LED
goes out, the self-test is complete and the charger is ready
to charge the battery.
► Position the power supply cord (2) so that it will not be
stepped on, tripped over, come in contact with sharp
objects or moving parts or otherwise present a tripping
hazard or be subjected to damage or stress.
8.2

Charging

WARNING
STIHL batteries contain safety features and devices which,
if damaged, may allow the battery to generate heat, rupture,
leak, ignite or explode. Never charge a malfunctioning,
damaged, cracked, leaking or deformed battery or use a
charger that has been damaged, @ 5.1. Never insert a wet
7 Before Starting Work
4
3
2
0458-794-8621-C