Disconnecting The Backpack Battery; After Finishing Work; Preparing For Transportation Or Storage - Stihl AR 1000 Manual De Instrucciones

English
WARNING
To reduce the risk of unintended activation, never store the
power tool with the connecting cord inserted into the AP
Adapter socket, @ 16. Always remove the connecting cord
before storing the power tool.
To connect the battery to a power tool with a battery
compartment:
3
2
1
► Line up the arrow on the connecting cord plug (1) with the
arrow on AP Adapter (3).
► Push the plug into the AP Adapter socket (2) with steady,
even pressure until it is fully inserted.
► Push the AP Adapter into the power tool's battery
compartment (4) until it engages with an audible click. The
battery and the power tool are now connected.
For further information on activating and operating the
power tool, see the instruction manual of the power tool
being operated with this battery.
Since a new battery is not fully charged, STIHL recommends
that you fully charge the battery before using it the first time,
@ 8.2.
16

12.3 Disconnecting the Backpack Battery

To reduce the risk of severe personal injury and property
damage from unintended activation, always unplug the
battery before assembling, transporting, adjusting, cleaning,
servicing, maintaining or storing the power tool and any
other time it is not in use, @ 5.4.
► Switch off the power tool as described in its instruction
manual.
► If a power tool with an integrated socket is used, pull the
3
plug out of the power tool socket with steady, even
pressure.
► If a power tool with battery compartment is used, remove
AP adapter from power tool's battery compartment and
then pull the plug out of the AP adapter socket with
steady, even pressure.
NOTICE
Avoid exposing the battery to excessive heat or cold or
prolonged periods of direct sunlight. Use or storage outside
the recommended ambient temperature range can reduce
the performance and/or service life of the backpack battery.
For further information on activating and operating the
power tool, see the instruction manual of the power tool
being operated with this battery.

13 After Finishing Work

13.1 Preparing for Transportation or Storage

To prepare the battery for transportation or storage:
► Switch off the power tool as described in its instruction
manual.
► Disconnect the backpack battery, @ 12.3.
► If the battery became wet during operation, allow it to dry
separately and completely before charging or storing.
WARNING
13 After Finishing Work
0458-794-8621-C