MELICONI HP EASY Instrucciones De Uso página 13

HEADPHONES (RECEIVER) -> Fig.1
Headphone details:
A. Volume control +
B. Volume control -
C. LED light (RED/GREEN/BLUE)
D. On/off button
E. Aux socket (3.5 mm jack analogue audio input)
F. Micro-USB socket for charging batteries
CHARGING DOCK (TRANSMITTER) -> Fig.2
Charging dock details:
G. Power outlet (USB-DC 5V)
H. ON-OFF/ CHANNEL CHANGE Switch (B/A/OFF)
I. Aux socket (3.5 mm jack analogue audio input)
L. LED light (RED/BLUE)
Charging the battery of the headset
• The battery must be charged before using the headset.
• To charge the battery, insert one end of the micro-USB cable into the "F" socket of the headset and the
other into any USB socket available (PC / SMARTPHONE charger, etc.).
• While the headphones are charging, the "C" led light is lit blue; the light will go out when they are fully
charged.
• Do not use or wear the headphones while the battery is charging.
Connecting the charging dock with the audio source
NB: Before making the connections, make sure the audio source (e.g. TV) and the base are switched off
(move the "H" switch to OFF).
• Using the dedicated cable (USB-DC 5V), supply power to socket "G" on the base, using any USB socket
available.
• Connect the base to the audio source, using the Aux Audio Cable (3.5mm analogue stereo jack).
• Switch on the base (move switch "H" to A or B), and check that the "L" LED light is lit red.
• Switch on the audio source (e.g. TV) and check that the "L" LED light on the base is lit blue.
NOTE: In some cases, you may need to enter the menu of the TV, activate the headphone output and turn
up the volume (refer to the user manual of the TV).
• Whilst remaining close to the charging dock, switch on the headphones by pressing down on button "D"
for a few seconds, until the LED light "C" turns green; release it.
• Put the headphones on and use the buttons "A" and "B" ONLY to adjust the volume and obtain proper
sound reproduction.
Do NOT use the TV remote control to turn down the volume; the base will not transmit if the audio signal
is too weak.
If the LED light "C" remains red, or if the headset does not reproduce the sounds, or there is interference
with the audio signal, press the "D" button briefly to pair the base to the headset.
If the problem persists, consult the "TROUBLESHOOTING" chapter
Installation
13