Publicidad
Idiomas disponibles
Idiomas disponibles
UK model
Amplifier
CD player
Other models
CD player
LINE
OUT
FIXED
VARIABLE
Le? ©)t
¢ If you have an analog power amplifier (except for UK
|
model)
Connect the amplitier via the VARIABLE LINE OUT jacks
using the supplied audio cord. You can adjust the output
level with the LINE OUT/PHONE LEVEL control on the
player or the LINE OUT LEVEL buttons on the remote.
Amplifier
CD player
LINE _OUT
EET
FIXED VARIABLE
©)
€)
Note
You cannot adjust the output level by pressing the LINE
OUT LEVEL buttons on the remote when using the UK
model
WWhen making digital hookups
You can avoid deterioration of the signal during
transmission, since the music signal output through
the digital output connectors retains digital form.
You can connect a digital component such as a
digital amplifier, D/A converter, DAT or MD. When
you connect a DAT or MD, you can make digital
recordings from CDs.
Note that you cannot use fading in or out function
(page 15) when making this connection.
¢ If you have a digital component with an optical digital
input connector
Connect the component via the DIGITAL OUT (OPTICAL)
connector using the optical cable (not supplied). Take off
the cap and plug in the optical cable.
Getting Started
European and UK models
Digital component
DIGITAL IN
OPTICAL
xy,
CD player
[
DIGITAL
OUT
OPTICAL
COAXIAL
a
Other models
CD player
OPTICAL
Digital component
DIGITAL IN
OPTICAL
¢ If you have a digital component with a coaxial digital
input connector (European and UK models only)
Connect the component via the DIGITAL OUT (COAXIAL)
connector using the coaxial cable (not supplied).
Digital component
DIGITAL IN
CD player
DIGITAL
OUT
OPTICAL
—- COAXIAL
Note
When you connect via the DIGITAL OUT connector, noise
may occur when you play CD software other than music, such
as a CD-ROM.
Setting the voltage selector (voltage
selector equipped models only)
Check that the voltage selector on the rear panel of the
player is set to the local power line voltage. If not, set
the selector to the correct position using a screwdriver
before connecting the AC power cord to a wall outlet.
110- 120V4
rp 220- 240 V
Connecting the AC power cord
Connect the AC power cord to a wall outlet.
Removing the notice sheet
The notice sheet is put on the player. Remove the sheet
before you use your player.
EN
Publicidad
