Publicidad
Idiomas disponibles
Idiomas disponibles
,_
WARNING:
Perform the following
steps after each use:
• Allow motor to cool before storing or
transporting.
• Store chain saw and extension
cord
in a well ventilated
area
• Store chain saw with all guards in
place and position chain saw so that
any sharp object cannot accidentally
cause injury.
• Store chain saw unplugged,
well out
of the reach of children.
SEASONAL
STORAGE
Prepare your unit for storage at the end
of the season or if it will not be used for
30 days or more.
If your chain saw is to be stored for a
period of time:
• Clean it thoroughly
before lengthy
storage.
• Store in a clean dry area.
• Lightly oil external metal surfaces
and guide bar.
• Oil the chain and use the bar sheath
(included) to cover bar and chain.
TROUBLESHOOTING
TABLE
WARNING:
Always stop unit and disconnect
from the power source be-
fore performing
all of the recommended
remedies below except remedies
that require unit to be operating.
TROUBLE
CAUSE
REMEDY
1. Chain tension
incorrect.
Chain does
not move
when trigger
switch is
engaged.
Chain clat-
ters or cuts
roughly.
Chain stops
during cut.
Oil inade-
quate for bar
and chain
lubrication.
Chain cuts
at an angle.
2. Guide bar rails pinched.
3. Trigger switch failure.
4. Circuit breaker tripped/
fuse failure.
1. Chain tension incorrect.
2. Cutters damaged.
3. Chain worn.
4. Cutters dull, improperly
sharpened,
or depth
gauges too high.
5. Sprocket
worn.
1. Chain cutter tops not
filed flat.
2. Guide bar burred or
bent; rails uneven.
1. Oil tank empty.
2. Oil outlet clogged.
3. Guide bar oil hole
blocked.
1. Cutters damaged
on
one side.
2. Chain dull on one side.
3. Guide bar bent or worn.
1. See "Check Chain Tension" in
Maintenance
section.
2. Repair or replace.
3. Contact Sears Service.
4. Reset circuit breaker or replace
fuse.
1. See "Check Chain Tension" in
Maintenance
Section.
2. Contact Sears Service.
3. Resharpen
or replace chain.
4. See "Chain Sharpening"
in
Service and Adjustments
section.
5. Contact Sears Service.
1. See "Chain Sharpening"
in
Service and Adjustments
section.
2. Repair or replace guide bar.
1. Fill oil tank.
2. Contact Sears Service.
3. Remove bar and clean.
1. See "Chain Sharpening"
in
Service and Adjustments
section.
2. See "Chain Sharpening"
in
Service and Adjustments
section.
3. Replace guide bar.
If situations
occur which are not covered in this manual, use care and good
judgement.
If you need assistance,
contact
Sears Service or the CUSTOMER
ASSISTANCE HELPLINE at 1-800-235-5878.
16
Publicidad
