Publicidad
Idiomas disponibles
Idiomas disponibles
Figure 1
To turn off the equipment, press the central power-off key for 2
seconds.
Select the outbound address of the legitimate banknote
Press the left key and hold it for 2 seconds to select the exit direction of
the legitimate bill. The arrow symbol is displayed on the left of the screen,
and indicates the direction of the note exit. The detector memorizes the
last setting.
Figure 3
Currency detection
It is not necessary to select the currency type as the detector
automatically recognizes the currency type when passing a bill, and
displays the current currency symbol, as shown in Figure 5.
Figure 5
When a banknote is fed into the feeder, the detector starts automatically.
For Euro and GBP. There is no limitation on the banknote insertion side
or the passing position in the feeder.
If the bill is legitimate, the pieces will be increased by one and the current
value will be added to the total value, the bill will go out in the selected
Figure 2
Figure 4
exit direction (Figure 6). When the total of parts is greater than 999 or the
total value is greater than 999999, the data will be automatically set to
zero.
Figure 6
If the banknote is suspicious, the equipment will reject it with 3
beeps, at the same time, the "ON / OFF" light lights up, the
corresponding error code is displayed in the "Pieces" display window
(Figure 7). Please refer to the troubleshooting section of this manual for
detailed error code information.
Report detection and deletion
After finishing detection, short press left key to go to report mode. To
check the detected legitimate banknote records, press the left key again
and again, the records of different denominations and their number of
pieces will be displayed successively (Figure 5).
If you insert a note while in the report mode, the detector will
automatically exit the report mode.
Mode
Press the "MODE" key and hold for 2 seconds to clear the detection
records.
At the bottom right in "ADD" with the introduction of each bill, the total
value will increase with its value and the number of bills will increase by
one unit, then the bill will go out through the selected direction. When the
number of banknotes exceeds 999 units or the total value exceeds 9999,
both values will start over at 0.
Press the Mode button, until "DEN" appears on the screen, the
equipment will only indicate the value of the entered banknote and will
not accumulate.
Figure 7
Publicidad
