Publicidad
Idiomas disponibles
Idiomas disponibles
English
Application
Access camera door loudspeaker for
Siedle Vario with integrated camera,
loudspeaker and microphone.
Automatic day/night switchover
(true day/night) and integrated
infrared lighting. Horizontal/vertical
pick-up angle: approx. 130°/100°.
Easy cabling thanks to pre-assem-
bled, plug-in cable connection.
Performance features:
• LAN interface: RJ-45, 10/100 Mbits
• Front grille made of weather and
UV-resistant polycarbonate
• Loudspeaker, voice volume can be
adjusted
• Durable electret microphone,
microphone sensitivity can be
adjusted
• Audio codec: G.722
• Button acknowledgement tone
• Nameplate illumination of the call
buttons can be controlled (time con-
trolled or demand-driven)
• Image format: 16:9
• Video codec: H.264, MJPEG
• Resolution: 1280 x 720 (HD),
352 × 288 (CIF)
• Image pick-up: CMOS sensor
1/2.7" 1920 x 1080 pixels
• Wide Dynamic Range (WDR)
Electrical voltage
Mounting, installation and servicing
work on electrical devices may only
be performed by a suitably qualified
electrician.
Scope of supply
• Access camera door loudspeaker
for Siedle Vario ACTLM 770-0
• RJ45 plug
• This product information
Terminal assignment
LAN
Network
1 Surface mounting
For the installation, a device junction
box with a depth of approx 60 mm
is recommended. Alternatively, an
electronics box can be used.
Connect the enclosed RJ45 plug-in
connector to the coupling module
installed on-site. Then insert into the
GA 612-... through the rear panel
and secure the housing to the wall.
Ensure the orientation is "up". Insert
the mounting frame in such a way
that the sealing film is located at the
upper and right-hand edge of the
mounting frame.
2 Flush mounting
Connect the enclosed RJ45 plug-in
connector to the coupling module
installed on-site.
Press the combination frame
together with the mounting frame
completely against the wall and
screw in the flush-mount housing
using the provided quick-locking
screw, turning a quarter turn to the
right (until the stop).
Installation and commissioning
The Access commissioning instruc-
tions and the Access planning and
system manual can be found in the
Siedle download area.
3 Factory reset
Press the reset button and hold it for
at least 10 seconds until the STATUS
LED flashes yellow. Release the
button within the 3 second flashing
phase and then press it again. It is
now reset to the default settings and
the STATUS LED lights up yellow for
2 seconds.
3 LED display
lights up in green Operating status
lights up in red /
Error
flashes red
Please see the Access Planning and
System Manual for further informa-
tion.
4 Call buttons for Siedle Vario
The call buttons are connected
to the door loudspeaker using a
ribbon cable. Up to max. 25 call
button modules can be connected
in any combination, allowing up to
max. 100 call buttons to be con-
nected.
Specifications
Operating voltage: PoE in accord-
ance with 802.3af
Ambient temperature:
–20 °C to +55 °C
Protection system: IP 54
Height of structure (mm): 3.5
Dimensions (mm) W x H x D:
99 x 99 x 35
5
Publicidad
